Aside from listing all of these parts on one page, this is an important ingredient for proper presentation of a show car. Unless otherwise specified, "CLIP" is a P-clip, "CLAMP" is a hose clamp, and all parts are zinc plated steel. I hope to post pictures of many of these parts. The original P-clips have rolled up edges to avoid scratching pipes or abrading the wiring cables.

for BOOTS (Rubber):
(Qty) PartNo.		Description
(1) 7H7956		Clamp for boot (large) - (clutch slave, steel wire ring)
(1) 7H7958		Clamp for boot (small) - (clutch slave, steel flat ring)
(2) 7H3565		Clamp for boot (tie rod end) - (steel wire pinch clip)
(2) ACA6004		Ring for boot (tie rod end) - (steel flat ring 1500 +early 1600)
(2) 7H3763		Ring for boot (tie rod end) - (steel flat ring) (new part number)
ref  7H3571		Boot (rubber) - (tie rod end 1500 +early 1600)
ref  7H3562		Boot (rubber) - (tie rod end 1600) (new part number)
(2) ACA5118		Clamp for seal (small) - (rack 1500) (flat band and screw)
(2) ACA6030		Clamp for seal (large) - (rack 1500) (flat band and screw)
(2) 3H2963		Clamp - seal - small - (rack 1600) (flat band and screw)
(2) BMK924		Clamp - seal - large - (rack 1600) (flat band and screw)
ref  130801		Seal for rack (gaiter 1500)
ref  AAA1682		Seal for rack (gaiter 1600)

7H7956 & 7H7958		AHH5248 (below)

for CABLES (Electrical):
(Qty) PartNo.		Description
(6) AHH5248		Clip for battery cable and harness - (tandem)
(2) AHH5506		Strap (steel) - tail lamp cable to rear cross member
(2) AHH5506		Strap (steel) - harness between optional dual horns
(2) ACH8979*		Strap (rubber) - harness and contol cables under dash (all MGA)
(1) ACH8979*		Strap (rubber) - dynamo cable to starter cable (all MGA)
* JOHN BULL REGISTERED 747240 Type S (search eBay)   * Anglo Parts 083.058   * Moss Motors USA 161-850
(1) PCR0311		Clip - cable to rear number plate bracket
(2) PCR0407		Clip for tail lamp harness to side member
(1) PCR0411		Clip for tail lamp harness to bump stop
(3) PCR0607		Clip - headlamp cable to front panel
(1) PCR0607		Clip - dip switch cable to goal post (LHD 1600)
(1) PCR0609		Clip - RH (negative) cable to starter switch
(2) PCR0811		Clip - main harness to wing bolt
(2) PCR0811		Clip - head and side lamp cable to wing bolt
(2) PCR1007		Clip - main harness to bulkhead
(1) PCR1011		Clip - main harness - dash to body bolt)

(Find PCR clip dimensions at bottom of page).

for CABLES (Pull and Turn):
(Qty) PartNo.		Description
(1) AHH5295		Clip for cable to 3-way piece & axle bracket - (hand brake)
(1) AHH5440		Clip for cable - (rubber strap for demist cable (with heater option)
(1) PCR0311		Clip - choke cable - to master cylinder blanking plate
(1) PCR0311		Clip - choke cable - (Twin Cam)
(1) PCR0507		Clip for cable to battery carrier - (hand brake)
(1) PCR0709		Clip for cable to dash (for speedo cable) (Attach to tunnel top bolt)
(1) ACH8539		Rubber sleeve for clip (speedo cable to dash)

(Find PCR clip dimensions at bottom of page).

for HOSES:			8G632
(Qty) PartNo.		Description
(2) 95482		Clamp - hose (fuel filler) (wire type hose clamp)
(2)  HCS1022		Clamp - hose (fuel filler) (new part number)
(4) 95621		Clamp - hose (radiator) (wire type hose clamp)
(4)  HCS1217		Clamp - hose (radiator) (new part number)
(4) 8G632		Clamp - hose & pipe, pump to elbow (Twin Cam)
(6) 301140		Clamp - hose - (flat band with screw) (with heater option)
(1) 14G80		Clamp - Air hose to air cleaner (4" thin steel band clamp)
(3) 14G80		Clamp - Air hoses to heater (4" thin steel band clamp) (with heater)
(2) ACA5290		Clamp - air pipe (valve cover vent hose) (pinch wire clip)
(1) AHH5714		Clip - air intake hose - (carburetor side) (4" P-clip)
(1) AHH5714		Clip - air intake hose - (heater side) (4" P-clip with heater option)
(1) AHH5714		Clip - air intake hose to heater - (4" P-clip with heater option)
(2) X19546		Clamp - water pump connector hose - (wire type hose clamp)
(2)  HCS1217		Clamp - water pump connector hose - (new part number)

For MGA Twin Cam bypass pipe:

(2) 8G518	Clamp, byass hose, thermostat end
(2) 2H3420	Clamp, byass hose, water pump end
(1) PCR1009	Clip, bypass pipe
(1) AEH492	Bracket, bypass pipe clip

2H3420

8G518

for MECHANICAL:
(Qty) PartNo.		Description
(3) 5843		Clip for starting handle - (spring-clip in boot)
(3)  ABD4825		Clip for starting handle - (spring-clip in boot) (new part number)
(1) 128978		Clip for support rod - (spring-clip under boot lid)
(1)  AAA1524		Clip for support rod - (spring-clip under boot lid) (new part number)
(1) AHH5460		Clip for support rod - (spring-clip under bonnet)

for PIPES:
(Qty) PartNo.		Description
(1) 1G2602		Clip - pipe (crankcase vent, 1600) (clip is part of pipe on 1500)
(1) 12H981		Clip - pipe (crankcase vent, 1600) (new part number)
(1) 11G80		Clip - pipe (crankcase vent, Twin Cam)
(1) 1H840		Distance piece - clip to crankcase (crankcase vent, 1600 only)
(1) 1H841		Clip - fuel trap mounting (bracket with screw)
(1) 1K204		Clip - (vacuum pipe to rear head bolt 1500)
(1)  12H90		Clip - (vacuum pipe to rear head bolt 1600)
(1) 54516		Clip - pipe to rear shock absorber bolt (fuel 1500)
(1)  AAA301		Clip - pipe to rear shock absorber bolt (fuel 1600) (was 54516)
(1) ACH8650		Strap - brake pipe to axle - (thin steel band)
(1) AEH550		Clip - drain pipes, carburetors (tandem for 2 pipes)
(3) AEH550		Clip - brake pipe to bulkhead (LHD AWDB) (for 2 pipes?)
(2) AHH5436		Clip - (water return pipe) (with heater option) Use PCR0809 below
(1) CHR0309		Clip - brake pipe to toeboard (LHD)
(1) CHR0309		Clip - brake pipe to floorboard (RHD 1500)
(2) CHR0409		Clip - clutch pipe to bulkhead (LHD)
(1) CHR0411		Clip - clutch pipe to pedal excluder bolt
(2) CHR0511		Clip - fuel pipe to bulkhead (1500, early 1600)
(2)  PCR0511		Clip - fuel pipe to bulkhead (new, always supply PCR0511)
(2) PCR0207		Clip - oil gauge pipe to bulkhead - front and rear
(1) PCR0307		Clip - main brake pipe to battery carrier
(3) PCR0307		Clip - thermometer pipe to bulkhead - front and rear
(1) PCR0309		Clip - brake pipe to RH toeboard bolt (AWDB)
(1) PCR0311		Clip - brake pipe (to pedal excluder bolt
(1) PCR0311		Clip - LH rear brake pipe to differential case bolt
(1) PCR0411		Clip - clutch pipe to pedal excluder bolt
(2) PCR0809		Clip - pipe - (oil cooler option)

Addendum 3/31/16:
BMC part numbers for the common form P-clips will look like this:
    PCR0411
PCR = P-Clip with Rolled edges
04 = tube diameter in 16ths of an inch -- (1/4-in dia pipe or cable)
11 = bolt hole diameter in 32nds of an inch -- (11/32-in hole for 5/16-in bolt)

Moss Motors has a web page listing P-Clips by dimensions if you need to buy a particular size.