On 5/10/2020, Mike Ellsmore wrote:
"One of our local MGA gurus (Jim McKenzie) came up with this puller for the rear housing of an MGA gearbox (1600 type). He decided to make it after overhauling the gearbox shown. The pin that goes into casing where the remote control attaches could have been a bit of flat steel but he had the piece of HRS with a bolt already welded, so he used it".


Going to have to remove the rear flange before pulling. Nice special tool if you do these things regularly. For me a couple of pry bars and a dead blow hammer get the job done.