The MGA With An Attitude
MGAguru.com MGAguru.com
Service Tools, Factory Issue
CAMSHAFT LINER REAMER, CUTTERS, AND PILOTS - 18G123A

Camshaft liner reamer (basic tool), cutters, and pilots
Camshaft liner reamer (basic tool), cutters, and pilots
18G123A - Camshaft liner reamer (basic tool), cutters, and pilots AJE5001.
This equipment is essential when reconditioning blocks, otherwise camshaft liners cannot be reamed in line, and in cunsequence the clearance between the camshaft journal and liner will be incorrect. This basic tool must be used with the cutters and pilots supplied separately and shown on this page. Full instructions for using the equipment wil be supplied with each basic tool.

18G123B - Camshaft liner reamer cutter, rear
18G123E - Camshaft liner reamer cutter, front
18G123F - Camshaft liner reamer cutter, center
18G123L - Camshaft liner reamer pilot, front
18G123S - Camshaft liner reamer pilot, rear
18G123T - Camshaft liner reamer pilot, front
18G123AB - Camshaft liner reamer pilot, centre
18G123AC - Camshaft liner reamer pilot, rear
18G123AD - Camshaft liner reamer pilot, rear (see 18G123S)
18G123AL - Camshaft liner reamer component fibre box (see next page)

NOTICE: These tools are used for camshaft bearings on the pushrod engines, and for the half-speed shaft bearings on the Twin Cam engine. These tools are not for use with the overhead camshaft bearings on the Twin Cam engine.

HomeBackTopNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2007 Barney Gaylord -- Copyright and reprint information