The MGA With An Attitude
MGAguru.com MGAguru.com
STEERING COLUMN BUSHINGS Cheap Adjustment - SR-102B

At 12:37 PM 12/5/05, Mike L in Toronto wrote:
>"I cut took out the old felt and pattern cut a steel shim (.005 or .008 or .010). Inserted the shim with a very thin layer of adhesive and then the old felt after soaking and greasing. Column shaft went back in as per your specs."

This is sounds like Grapes of Wrath material, but if you have some shim stock lying around this might be a quicker fix than ordering a replacement felt bushing.

On Jan 27, 2022 Peter Stevenson in Aubusson d'Auvergne, Auvergne, France wrote:
"Once I realized it was going to take a lot of faffing to fit the new 'too thick' felt, I fitted a shim (can't remember if it was one or two thicknesses) made from an aluminum drink can. Fitted between the column tube and the old felt. Everything feels like it should do, no rattling of steering over the bumps. I think it made for better location than butchering the new felt".

HomeBackNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2005, 2020 Barney Gaylord -- Copyright and reprint information